Introduction
This patch can only be installed on an existing ControlDesk 3.7.2 installation (dSPACE Release 7.2).
Problems Fixed by This Patch
Please refer to the Installation Notes that you can download below.
Limitations
This setup does not work if ControlDesk 3.7.2 Patch 1 is currently installed.
If you have successfully installed Patch 2 or 3, Patch 1 must have been uninstalled before. In this case, you can install Patch 4 directly.
If you have currently installed Patch 1 and install Patch 4, the setup is executed but no new files are copied to the system. Then you have to uninstall both Patches, 1 and 4, before installing Patch 4 again.
Perform these steps to uninstall Patch 1 (and 4):
Installation Notes & Download
Date | 2014-06-03 |
Software Type | Experiment and Visualization Software, Bus and Network Software, ECU Interface Software |
Product | ControlDesk, RCP and HIL Software |
Information Type | Patches |
Information Category | Troubleshooting |
dSPACE Release | Prior to 2013-A |
Drive innovation forward. Always on the pulse of technology development.
Subscribe to our expert knowledge. Learn from our successful project examples. Keep up to date on simulation and validation. Subscribe to/manage dSPACE direct and aerospace & defense now.